N male connectors that eliminate the need to trim coax cable braid introduced by RF Connector

SAN DIEGO, 12 Aug. 2013. RF Connectors in San Diego is introducing two N male connectors to simplify the proper installation of RF and microwave connectors onto coax cable by eliminating the need to trim the braid during cable preparation.

The RFN-1006-49I has a solderless captive pin and the RFN-1006-4I has a crimp pin. Both connectors are compatible for high performance cables such as Times Microwave LMR-400, CommScope CNT-400, Belden 9913, and RF Industries RFI-CU400.

Combination hex and knurl coupling nuts enable tightening by hand or wrench. White Bronze (tri-metal) plating eliminates tarnishing while providing improved electrical performance and reduced passive intermodulation (PIM).

VSWR of less than 1.1 to 1 to 3 Ghz and less than 1.2 to 1 to 8 Ghz comes from an enhanced impedance-matching design. Industry-standard tooling can be used for cable preparation and crimp termination.

Heat shrink and assembly instructions are included with each connector, and VSWR charts are available. The connectors are available from RF Connectors Distributors throughout the U.S., Canada and Mexico. RF Connectors is a division of RF Industries in San Diego.

For more information contact RF Connectors online at www.rfcoaxconnectors.com.